I am looking to buy a 914 engine case. I need a case that has not been line bored (and ideally doesn't need to be line bored). I am somewhat tight on funds (who isn't) so I need a case that is as close to ready to use as possible.
Please let me know if you have one that you would be willing to part with.
Thanks
What's your timing? I have two cases @ the machine shop getting cleaned and checked over. I will use the better of the two but the other will be professionally checked out and i expect just fine. It is a late model 2.0. I'll have a spare crank, rods, and pistons then too. Main problem is my machinist is slow......
Mike
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)