Printable Version of Topic
Click here to view this topic in its original format
914World.com _ FS/WTB: 914 Parts _ WTB - Rear Trunk Floor Pan
Posted by: cpfoster Jan 18 2014, 10:09 AM
Need the rear trunk floor pan for restoration of '74 Zambezi green 2.0L that is finally ready to go to the shop for light body work and paint.
Need especially the area most prone to rust, where the trunk pan seam is under rear tail lights.
Will pay cash or have a lot of parts if want to trade.
Can pick-up / cut out myself if an hour or so drive from Washington DC or Baltimore area.
Thanks,
Chris
Posted by: bdstone914 Jan 18 2014, 11:55 AM
Probably best to buy it new. I have not seen many parted out cars with a good trunk floor.
Restoration Designs has them.
http://www.restoration-design.com/mm5/merchant.mvc?Store_Code=rd&Screen=PROD&Product_Code=P335
Posted by: cpfoster Jan 18 2014, 12:39 PM
Probably best to buy it new. I have not seen many parted out cars with a good trunk floor.
Restoration Designs has them.
http://www.restoration-design.com/mm5/merchant.mvc?Store_Code=rd&Screen=PROD&Product_Code=P335
Thanks, I was thinking the same thing, but figured I'd throw the "Hail Mary" out there
Posted by: Vysoc Jan 18 2014, 02:42 PM
PM Sent
Posted by: mepstein Jan 18 2014, 03:10 PM
Probably best to buy it new. I have not seen many parted out cars with a good trunk floor.
Restoration Designs has them.
http://www.restoration-design.com/mm5/merchant.mvc?Store_Code=rd&Screen=PROD&Product_Code=P335
the back of the trunk is usually rusty under the seam sealer.
Posted by: cpfoster Jan 18 2014, 07:36 PM
I'll take the advice and just get the repro panel - thanks guys !
Posted by: barefoot Jan 19 2014, 05:19 PM
Got mine from AA slightly lower price than rest.
here's what was left, used some small panels for hell hole area.
Posted by: cpfoster Jan 19 2014, 07:30 PM
Barefoot - Thanks for the pic, I need the piece of the the metal on the right edge of the pic you posted. I'm working on a trade with Vysoc now for the repro panel. Will let you know if something falls thru.
Thanks,
Chris
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)