I am looking for a set of 914-6 headers as my theory of turning around a set of 911 headers works on one side, but not both.......... Anything out there FS? Or sources in addition to Bursch.
size IS important ...What are you looking for
1 1/2
1 5/8
1 3/4
Really should be sized to engine
Best for the price is MSDS. He also gives a 914 discount. He has an ad in the member vendor section. For a 3.0 you should run 1 5/8"
I ran his headers and muffler back in the day with my 2.7. Sounded awesome!!! Marty no longer makes the mufflers.
very pleased with their headers...and he's local for p/u
List price on the MSDS is $130 more than the Bursch and I don't see any advantage. I don't know how much of a discount the folks at MSDS give but if it is over $130 I would consider it. If not, I see no reason to spend the extra dough.
Also, I would do some studying about which headers will work best for your application/desires before settling in on a size.
Thanks to all for the input.
This is a close-to-final item to resolve. I talked to Bursch in Pasadena and they make a set for around 6 bills. Any of the sizes are available and this is a build-to-suit and they recommend 1&5/8 for a 3.0 with carbs - As Steve's experience accounts for.
Now to go rob another bank......................
http://www.automotion.com/headers-bursch-1-5-8-for-914-6-porsche-1970-1972.htmlhttp://www.automotion.com/headers-bursch-1-5-8-for-914-6-porsche-1970-1972.html
I see heat in your future Forrest.
I recently bought set of Bursch through Ecklers and they did not fit......Bursch was playing games with " did you do this and that " ...send pictures of why not ........etc etc etc
I finally told Ecklers I bought from them and it was up to them to handle and not pass off Bursch's BS on me....
Net result is Ecklers treated me right and took back......While I understand manufactured products can always be "wrong " it is how the company resolves the problem that makes it a good or bad supplier. As far as I am concerned Bursch F'd me around so my dollars wont go there again.
MY 2 cents
One huge reason among many that I would choose msds. Marty -the owner, is a member here and has always done right for world members.
+1 for MSDS
Running Marty's 1.625" on my 2.7
Thanks for the insight fellas. I am now understand you have to watch out for folks that sell ill fitting headers......... and seats
http://seattle.craigslist.org/est/pts/5940614182.html
cross link to this
http://forums.pelicanparts.com/porsche-914-914-6-technical-forum/941214-914-6-header-options.html
guys - here is the solution to adapter stubs to match various "short" headers to a stock 914/6 or 911 muffler position
inquiry & several other current running posts by Haag on World & Pelican caused me to search for an answer this morn
- one can buy the Porsche exhaust flanges from SPD http://www.spdexhaust.com/ImportB.html
PO617121 1.50”
PO617122 1.63”
PO617123 1.75”
Air Cooled Opposed 6 cyl. 1964-1998 911 914-6
problems solved
I could be interested if it is a headers only deal / and for what cost if it is? Thanks for the post
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)