Selling a spare stainless steel drivers/left side 2.0 heat exchanger. One of the pipes had been cracked and repaired in the past. When I got it, I tested it with Bruce's block off plates to check for leaks and found a pinhole leak at the weld. It had been welded with mild steel, so I removed the weld and re-welded with SS mig wire and tri-mix gas. There were some buggered welds on the shield edge that I also replaced and chased. It's not super pretty, but it's in good condition now.
Asking $350 plus shipping (probably $50ish?). PayPal F&F (if no F&F, add for fees). PM with questions and interest.
Attached image(s)
Im not your buyer but has this been pressure tested?
Hi Jeff. Thanks for prompting the clarification. Yes. Tested again after the repair and holds pressure.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)