I needed a flywheel for a manual trans I ordered one from this place and this is what they sent. It doesnt look like any flywheel I ever saw. It does have the starter ring though. What the heck is this?
Attached image(s)
flip side
Attached image(s)
you really need to a get a manual for a 928
some 928s have basicly 1 flywheel, but it has 2 friction surfaces for the 2 clutches it uses...
It is the right one if you have the dual friction plate set-up--if your 928 is an '86 or older that is it...
I'm not a 928 person but dont they have a torque tube behind that that actually attachs to the trans at the rear wheels.
Yea I know but how would this hook to the flywheel?
I was trying to get this figured with out bugging rick. Its one of the two flywheels he needs to make the adaptor to put the engine on the trans. It just doesnt look right with no center. I do now have a set of manuals for the 928 and 914.
I was looking at the bird board at parts and they list a rubber convertor center. Possible that is what's missing?
Part number?.... if it has on it (928 116 033 22) that is the intermediate ring. One clutch plate goes on one side, the other clutch plate on the opposite..then the pressure plate attaches to the entire assembly.
The flywheel will start with numbers (928 102 .........) and then vary based on year/tranny type. 86+ went to a single clutch plate on the manual tranny's.
Upon further review they sent the wrong part. I was checking for the pn when I noticed their inventory number is not the number I ordered. It should be 7140 not 6872 some one just grabbed the wrong part.. We will see monday if they will make it good.
Idiots! They sent the intermediate plate!
Need a spare http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7940875732&sspagename=ADME%3AB%3ASS%3AUS%3A1
Felix
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)