914World.com [Powered by Invision Power Board]

Posted by: Mwood Jun 9 2014, 02:34 PM

Hey I am getting some cv axles back from machining in a couple weeks,
is there a part number for the cup/thrust washers that go on the inside of the joint?
or have any idea where they can be purchased
I have no idea where mine went and I will need them for the rebuild.
need 2

also has anyone got a regular snap ring to work instead of those annoying C rings that hold the joints on the front side?

thanks in advance

Mitch

Posted by: John Jentz Jun 9 2014, 07:08 PM

QUOTE(Mwood @ Jun 9 2014, 04:34 PM)

Hey I am getting some cv axles back from machining in a couple weeks,
is there a part number for the cup/thrust washers that go on the inside of the joint?
or have any idea where they can be purchased
I have no idea where mine went and I will need them for the rebuild.
need 2

also has anyone got a regular snap ring to work instead of those annoying C rings that hold the joints on the front side?

thanks in advance

Mitch

Dealer

Posted by: dangrouche Jun 9 2014, 10:16 PM

removed

Posted by: bdstone914 Jun 10 2014, 06:34 AM

If you buy the right tool the C clips are not a problem. I bought K D tool long ago for $ 12 that works great. It has knurling
On the flat tips so it does not slip. Some cv's do use snap rings.

Posted by: brant Jun 10 2014, 08:00 AM

Bruce, does that to have a part number on it? Iwill look for one

Posted by: Mwood Jun 10 2014, 09:03 AM

Found my washers, good advice on the tool
I also wonder about a part number

Printable Version of Topic