My fresh air / heater slide controls never lined up correctly.
Recently I had reason to have to pull out my gas tank, so I thought it a good time to make some cable adjustments - since I had more room.
There are three cables that control the fresh air vents and motor. So while I'm adjusting the cables, I find out that ONE of my clamps is broken - to the point it is useless.
They are the tension clamps that hold the cable ends close to the vent levers.
I can't find a part number in PET, not sure if the LPS will have something that will work.
Anyone know a part number or replacement for this???
Thanks,
Len
Found it....
90157191900
Dug deeper
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)