Printable Version of Topic

Posted by: Mikey914 Feb 19 2015, 11:09 AM

Just completed the mold and will have in 25-30 days the full production run. Will be including in my complete kits in the future.

If yours look like mine did (or what was left of them), you can use a set of these. I'm quite happy with the quality and fit of these. I started on these a while ago, but the mold was actually more complicated than it looks, I finally solved the problem and will have production on these shortly.

So, who needs them?

Also I can add in other items that will be available with the GB that can save a few $$.
Thanks,
Mark


Attached image(s)

Posted by: Mark Henry Feb 19 2015, 11:52 AM

Neat..... but I'm wishing you would come up with a low profile wart solution.
That is before I just weld mine over next winter.

Posted by: luskesq Feb 19 2015, 03:42 PM

I'd be in for a set of cap seals Mark. Thanks,

Keith

Posted by: Cairo94507 Feb 19 2015, 09:53 PM

+100! I really wish we had a low profile wart with LED side marker/blinker lighting. I will not remove the warts from my car but would seriously love low profile warts.

Posted by: pneuhyde Feb 20 2015, 02:08 AM

Agreed

Posted by: euro911 Feb 20 2015, 04:31 AM

Is there already a source for those push-in screw anchors for the side marker bases?

Posted by: Mikey914 Feb 20 2015, 06:19 AM

I have them too.

Posted by: euro911 Feb 20 2015, 02:15 PM

Mark, I didn't see these side marker light cap seals on your GB page (yet). I have a cart of other products I'd like to get on the same order ... how should I proceed?

Posted by: Mikey914 Apr 5 2015, 09:39 AM

These are done now for whoever wants them

http://www.shop.914rubber.com/914-Side-marker-electrical-boot-91463121810-set-of-2-914SMEB.htm