Printable Version of Topic

Posted by: Jengah Nov 18 2019, 09:00 PM

I've seen a lot of V8 engine swaps, but none of them ever needed to notch out more than a 6" section of the trunk metal between the shock mounts. Does anyone have any insight as to why this one would be mounted in a way that causes the valve covers to extend into the trunk area. My thoughts are:
a.) big block engine (but it looks like a SBC)
b.) DIY mounts
c.) a strange (non Chevy) engine that is longer than most

Thoughts???

Posted by: mepstein Nov 18 2019, 09:10 PM

....

Posted by: mepstein Nov 18 2019, 09:26 PM

Lots of hack jobs with almost any conversion. I’ve seen some that look almost factory installed. The guy who started on my Suby build cut out the entire rear trunk firewall from tower to tower and welded in a huge pipe. it’s one of the reasons I was able to get the chassis so cheap.

Posted by: tygaboy Nov 18 2019, 09:55 PM

A bit hard to tell from the angle of the pic but those look like really tall valve covers. Tall enough to need that cut to clear?

Posted by: Chi-town Nov 18 2019, 10:36 PM

They probably sat the engine more rearward than Renegade to clear a normal water pump setup

Posted by: cali914 Nov 18 2019, 11:03 PM

QUOTE(Chi-town @ Nov 18 2019, 08:36 PM)

Posted by: sixnotfour Nov 19 2019, 02:52 AM

Posted by: Superhawk996 Nov 19 2019, 05:42 AM

Yeah, don't do that.