Will the stock 3.6 intake clear a closed stock engine lid with cross brace?
“Asking for a friend.”
Actually I need to know so that I can make a GT lid with a lightened cross brace or one with the brace removed for a 914 with a 3.6. Thanks
Sergio
The GT engine lid whisperer
I was able to fit the 3.6 intake under the stock lid, so the GT lid should work fine.
Clay
As you can see from my pics above that small rubber elbow is the highest point on my engine setup and that is the only piece i'd be worried about hitting the engine lid.
I think i actually cut a section of the cross brace from my GT lid but i'm not sure that was really needed.
PS: I can go down to the garage later and take some pics and measurements
Thanks you gentlemen.
After rotating the intake on my early 993 build, the stock engine lid fit fine.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)