I just bought a couple of '73 window regulators for my '72.
Holding them up to the door I see they are not just bolt in replacements. Does anyone have a break down diagram or good picture that shows the proper installation and hook ups for installation.
Tx
Edit:
Actually I would be happy to see a couple of pictures of someone's doors with the door panels off (windows up and down) so I could get an idea of the angles that the newer regulators go in on.
Tx
I had this problem when I replaced a door on my race car (1973) with a door from a 1970. I finally cut the center section of the door (part with mounting holes) off the damaged door and then cut the replacement door to match and weled it in. Was a small pain in the ass but I got over it. Good luck.
This is usually acomplished by replacing the early doors w/late.
Not quite the replies I was hoping for, anybody else have better news for me?
TX
I guess I will have to get out the old protractor and figure this one out for myself. It was something that I thought most owners of older cars had already done.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)