I noticed a timy paint bubble by one of my windshield nozzles and, knowing there was going to be some rust under it, I peeled it up. !!! Ack! There seems to be more than a bit... !!! How best to sanitize this? The rust is just on the surface, so should I just sand it off and repaint POR-15 it and paint?
Attached image(s)
You got it. At least it isnt in a structural area.
B
Check underneath the cowl, too. If you have rust there, it could have eaten it's way down to the other side of the metal.
-Rusty
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)