Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Shift knob
Posted by: familienauto Sep 11 2007, 11:48 PM
Hello again everyone,
So I am putting the shift knob back on after redoing the carpet, and of course it's a little loose. Should I replace that little ring (compression fitting?)? It seems to me that there was a thread on this recently and that you could find those at the hardware store, but I can't find the thread.
Thanks,
Zach
Posted by: pfierb Sep 12 2007, 12:29 AM
QUOTE(familienauto @ Sep 12 2007, 01:48 AM) 
Hello again everyone,
So I am putting the shift knob back on after redoing the carpet, and of course it's a little loose. Should I replace that little ring (compression fitting?)? It seems to me that there was a thread on this recently and that you could find those at the hardware store, but I can't find the thread.
Thanks,
Zach
That piece is called the crush ring and should be replaced I believe that you can get one at most of the usual Porsche parts and accessory places on line.
Posted by: Toast Sep 12 2007, 12:44 AM
Teflon tape works too. 
Posted by: ahdoman Sep 12 2007, 08:23 AM
Whatever you do don't GLUE IT ON like one of the previous PO's did on my car!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)