Hello all.
My question concerns the 914 stock ignition.
Can a Jacobs Ultra coil be used in the 914 reliably without compromising the ignition wiring harness?
Thanks
Mike
North Haven Ct.
1975 1.8l
The stock ignition wiring is basically a +12V switched (from ignition) wire run to the + side of the coil.
From there, you have your triggering on the - side of the coil (distributor points or compufire/pertronix), your trigger for the fuel injection and tachometer.
Whatever system you install will have to provide an output for your tach/injection.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)