While I was taking the cam bearings out of my 2.0 case I managed to put a small scratch in one of saddles. The screwdriver slipped as I was using it to pry out the bearing by the little tab on one side.
Does this scratch matter, and if so what do I do about it? Right now I can feel a little raised edge at the end of the scratch with my fingernail. I can take a pic later if that will help.
Still learning how not to do these things... <_<
Rub it out real careful with a half round needle file. Don't go back and forth, just forward one stroke at a time. It will be fine.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)