I have been looking for pictures of 914s with either pop riveted or bolted on flares. I remember seeing a really nice(red? orange?) one that had been done recently but cannot find the pictures by using the search.
I am doing a racecar project and am getting some ideas.
Thanks
Kyle
I used Sheridan Motorsports rear flares on my car and installed them by using threaded inserts on the sheet metal then running stainless round head alen bolts and clear nylon washers through the fiberglass. Most guys either bond them on or use quick release dzus fasteners. I wanted to be able to remove them easily but knew I wouldn't be doing it often. It's a bit racecar looking but I kinda like it that way. Even continued the exposed bolt thing on the tail as you can see. Roger Sheridan made the tail too. At 4" tall the tail is worthless but it looked like something was missing without it so I threw it on. His fiberglass body parts are top notch and he is a great guy to deal with. If I did it again I would have put his front end on the car too instead of the RDR front fenders and nose section which are also bolted on but hidden. Paul S.
OT, but gorgeous car 914junkie.
The rivet/bolted on look does make the 914 look very much like a race car, very slick looking IMO, however, mine or bondo'd on, car came that way.
There could be benefits to being able to pull the flares off
1. More room to get the wheel off
2. More room to work around the brake components, instead of sitting inside the wheel well.
3. More access to suspension/possible steering components
You might have heard of or seen my car.............
Factory flares with black rivets.
Ilike it.
Killer action shot, nice flair install.
Race car with riveted flares with welting in between.
John
Dr. Gary's is the install that I prefer iffin you weren't going to weld. I did FG flairs's with pop rivets 'cause I figured they will get banged up in W2W. I didn't use welting (was a personal choice after buying it) - didn't like the look of the black line...
Painted up two sets of flares so I have extra's ready if needed.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)