Hi,
I'm putting my engine back together and I can't find the torque wrench settings for the oil pump, same for most of the other parts of the engine. Does someone has the settings for them (oil pump, oil filter holder, ...)?
Thanks,
- Juergen
Standard 8.8 hardness 8mm studs, standard 8mm torque. I can't find my type 4 book to look it up specifically, but it's 17 or 18 ft lbs on all of the charts that I can find. That's for a bolt and nut through steel. I still go 13-15 because all of our stuff is mostly into magnesium or aluminum.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)