Some of you may know I have a six that met a concrete light post dead center at speed.
I have a rust free 1970 -4 car I purchased to use for parts for my rust free 6. Up til now I haven't been able to convince myself that cutting a good 4 cylinder car is the right thing to do.
So save this car from the knife. I am not selling the 4. I am looking to purchase an early shell (70 to early 72) with a rust in the rear and a good front clip. The car needs to have the early front panel and good frunk floor.
Anyone have a shell or a good clip they want to sell?
Have you contacted Vince in Hesperia CA?
A bit far from you but dry desert...
Thanks not yet. I am sure he could ship it too.
Still have one ahead of the 6. That was a great road trip. Great friends along the way. Got to see Slits shop when we picked the 2.7-S. great BBQ. I am not sure I knew about Vince then. I will check with him this week.
Spoke with Vince today. Nada zip zilch
Take the panel off the 4 to use on the 6 and replace it with a late model panel. The 4 won’t go down drastically and the 6 will go up dramatically.
I think I located a clip. Garold has a car that may provide what I need.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)