Hello from the frozen wilds, of Manhattan Kansas. |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Hello from the frozen wilds, of Manhattan Kansas. |
ClayPerrine |
Jan 15 2005, 07:05 AM
Post
#1
|
Life's been good to me so far..... Group: Admin Posts: 15,820 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille |
It's a balmy -15 here, and this morning we are off to Lawrence's garage to put the carbs back on his /6 and adjust the valves.
Yoder and I drove up yesterday, and Ginter met us here. We spend the evening last night drinking, rebuilding carbs in his apartment and watching the Sopranos. Yoder is now hooked on it. BTW... a dead bug in your Weber carb does not make for good running......... (IMG:http://www.914world.com/bbs2/html/emoticons/lol2.gif) Gotta go.. Lawrence is cooking breakfast. (IMG:http://www.914world.com/bbs2/html/emoticons/chowtime.gif) |
TheCabinetmaker |
Jan 15 2005, 07:27 AM
Post
#2
|
I drive my car everyday Group: Members Posts: 8,309 Joined: 8-May 03 From: Tulsa, Ok. Member No.: 666 |
You guys seen your emalis about MUSR?
|
URY914 |
Jan 15 2005, 09:14 AM
Post
#3
|
I built the lightest 914 in the history of mankind. Group: Members Posts: 123,027 Joined: 3-February 03 From: Jacksonville, FL Member No.: 222 Region Association: None |
Damn, -15!!!
Seven of us are going sailing today on a friends (big) boat. Spending the night, acting like pirates! AAARRRR!!! (IMG:http://www.914world.com/bbs2/html/emoticons/beerchug.gif) Paul |
Joe Bob |
Jan 15 2005, 09:19 AM
Post
#4
|
Retired admin, banned a few times Group: Members Posts: 17,427 Joined: 24-December 02 From: Boulder CO Member No.: 5 Region Association: None |
Getting ready to go mow the lawn.....polish the 911 and do a whine and cheese run in the whiney country.... (IMG:http://www.914world.com/bbs2/html/emoticons/mueba.gif)
Oh yeah....is Ginter wearing his panty hose for warmth? He gets cold so easy..... |
Katmanken |
Jan 15 2005, 09:22 AM
Post
#5
|
You haven't seen me if anybody asks... Group: Members Posts: 4,738 Joined: 14-June 03 From: USA Member No.: 819 Region Association: Upper MidWest |
Akkkk!
That's rough! Kansas is flat country. I lived in Salina for 3 years as a kid and can testify there isn't anything to stop the wind.... Except mebbe a wire fence somewhere in South Dakota..... (IMG:http://www.914world.com/bbs2/html/emoticons/biggrin.gif) Ken |
dennisc |
Jan 15 2005, 09:35 AM
Post
#6
|
Member Group: Members Posts: 90 Joined: 1-September 04 From: Marshall, MO Member No.: 2,671 |
The light bulb just went off. "Rusty's Last Chance Saloon" in Manhatten? (IMG:http://www.914world.com/bbs2/html/emoticons/beer.gif)
|
seanery |
Jan 15 2005, 09:57 AM
Post
#7
|
waiting to rebuild whitey! Group: Retired Admin Posts: 15,854 Joined: 7-January 03 From: Indy Member No.: 100 Region Association: None |
we need a "How heat exchangers work" from yoder...
|
IronHillRestorations |
Jan 15 2005, 10:01 AM
Post
#8
|
||
I. I. R. C. Group: Members Posts: 6,761 Joined: 18-March 03 From: West TN Member No.: 439 Region Association: None |
Yea, I sold some parts to a guy out there. I remember him saying "I love my 914, there's this one curve on the way home", probably one of six within 80 miles! (IMG:http://www.914world.com/bbs2/html/emoticons/laugh.gif) Poor guy should ride with me to the post office, or to the golf course, or to the sitters.... |
||
ClayPerrine |
Jan 15 2005, 08:06 PM
Post
#9
|
Life's been good to me so far..... Group: Admin Posts: 15,820 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille |
Hey Zois...
I just told Ginter about your comment about the panty hose. He says he is wearing YOUR panty hose to keep warm... (IMG:http://www.914world.com/bbs2/html/emoticons/lol2.gif) |
Joe Bob |
Jan 15 2005, 08:23 PM
Post
#10
|
Retired admin, banned a few times Group: Members Posts: 17,427 Joined: 24-December 02 From: Boulder CO Member No.: 5 Region Association: None |
Tell him to watch out for the skids marks....
|
Gint |
Jan 15 2005, 09:54 PM
Post
#11
|
||||
Mike Ginter Group: Admin Posts: 16,093 Joined: 26-December 02 From: Denver CO. Member No.: 20 Region Association: Rocky Mountains |
(IMG:http://www.914world.com/bbs2/html/emoticons/burnout.gif) That's a given. (IMG:http://www.914world.com/bbs2/html/emoticons/finger.gif) XOXOX! (IMG:http://www.914world.com/bbs2/html/emoticons/wub.gif)
|
||||
rick 918-S |
Jan 15 2005, 11:40 PM
Post
#12
|
Hey nice rack! -Celette Group: Members Posts: 20,680 Joined: 30-December 02 From: Now in Superior WI Member No.: 43 Region Association: Northstar Region |
How's it coming guys? (IMG:http://www.914world.com/bbs2/html/emoticons/wavey.gif)
|
ClayPerrine |
Jan 16 2005, 06:12 AM
Post
#13
|
Life's been good to me so far..... Group: Admin Posts: 15,820 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille |
Update... 06:00 Sunday.
Yesterday we got the car back together and tried firing it up. We had a bit of a problem with the turbo valve cover on the left bottom getting it back on the engine, and in the process of transporting the carbs from Rusty's apartment to the garage a bowl drain plug got broken. FYI- the bolt is a 7mm x1.0 thread, 10mm long. We almost got it running, but the battery went dead. We went a bought a charger, took it back adn hooked it up, then called it a night. BTW.... you know how they are on the board. Well they are really like that in person. We went to the hardware store looking for springs for the accellerator pumps (seems the DACO left one out the last time the carbs were done), and the clerk told us that we were the funniest group to come in all day. (IMG:http://www.914world.com/bbs2/html/emoticons/screwy.gif) But it's too F-ing cold here!!!!!!! |
ClayPerrine |
Jan 16 2005, 12:59 PM
Post
#14
|
Life's been good to me so far..... Group: Admin Posts: 15,820 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille |
Got it fired up!!!
We changed the plugs and the car fired right up. It ran OK, but it seemed to miss. So we started checking, and we had one bad plug wire. The plug would fire, but with a weak spark and it would foul out. We bought wires for a SBC chevy locally and changed the ends for the /6 ends. Changed the coil in the process, and it runs great over 1500 RPMs. We can't get it warmed up enough to set the idle mixture and idle carb balance. We are back at Rusty's. Gint left shortly after we fired the car. Joe and I are leaving right after lunch. It's been a good weekend. I don't think Rusty will be taking a hammer to his car now...... (IMG:http://www.914world.com/bbs2/html/emoticons/smilie_pokal.gif) |
hi ho silber |
Jan 16 2005, 01:09 PM
Post
#15
|
Member Group: Members Posts: 97 Joined: 18-January 03 From: Troy, IL Member No.: 168 |
Sounds like a successful intervention (IMG:http://www.914world.com/bbs2/html/emoticons/biggrin.gif)
Where are all the pictures? Thanks again for stepping up and saving this car from the big hammer (IMG:http://www.914world.com/bbs2/html/emoticons/headbang.gif) Dave |
ClayPerrine |
Jan 16 2005, 01:11 PM
Post
#16
|
Life's been good to me so far..... Group: Admin Posts: 15,820 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille |
What pictures?????
We were way to busy to take pictures... |
J P Stein |
Jan 16 2005, 01:44 PM
Post
#17
|
||
Irrelevant old fart Group: Members Posts: 8,797 Joined: 30-December 02 From: Vancouver, WA Member No.: 45 Region Association: None |
Whatdaya mean, no pics? There's 4 of ya, 2 with their asses in the air workin' on the motor......what were the other 2 doing?.....nevermind, I don't wanna know (IMG:http://www.914world.com/bbs2/html/emoticons/laugh.gif) |
||
Rusty |
Jan 16 2005, 02:17 PM
Post
#18
|
Wanted: Engine case GA003709 Group: Admin Posts: 7,952 Joined: 24-December 02 From: North Alabama Member No.: 6 Region Association: Galt's Gulch |
Yep... thanks to Clay and Gint and Joe for coming by.
Unlimited beer, steaks and brats on the grill, Soprano's on TV... a good weekend. Looks like my frustration with the car wasn't really due to the valves. They weren't too far off, and my overall method was pretty sound. Right now, it's just too damned cold (even with propane heat in the garage) to get the car warm enough to finally finish off carb adjustments. Clay was right about the carbs being a bit buggy. Somehow there was a ladybug in one the float bowls. A full rebuild on the carbs really helped out, and the old plugs were fouled a little bit. Considering it is so cold, the /6 didn't want to start with them. the only thing we really didn't get done was replacing the oil lines. But that's a project for another day, I think. It's not an emergency, and I can do that at the next oil change. Yep, we were pretty busy to take pictures (that, and I think the camera would freeze!) OTOH, Gint makes an excellent little toolwench. (IMG:http://www.914world.com/bbs2/html/emoticons/laugh.gif) -Lawrence |
Gint |
Jan 16 2005, 06:45 PM
Post
#19
|
||
Mike Ginter Group: Admin Posts: 16,093 Joined: 26-December 02 From: Denver CO. Member No.: 20 Region Association: Rocky Mountains |
I shoulda spent 5 minutes and just bled that fuckin clutch right there on the Manhattan KS. ice. That's what I ended up doing in my driveway anyway (except for the ice part, much warmer here (IMG:http://www.914world.com/bbs2/html/emoticons/cool.gif)) . Gawdammm cold plastic hose. I need to shower after the brake fluid shower I just had.
Thoughly enjoyed myself this weekend Rusty. Thanks. And MicroClay, love ya man. I WAS just havin fun with you. I hope you know that; I just wanted to make certain. You're one of the finest people I know.
That's why it's called debugging. (IMG:http://www.914world.com/bbs2/html/emoticons/laugh.gif) |
||
Lo-Fi Version | Time is now: 27th September 2024 - 09:53 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |