FS 1973 914-2.0, For Parts or Restoration |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
FS 1973 914-2.0, For Parts or Restoration |
teds33 |
Oct 1 2020, 09:01 PM
Post
#1
|
I'm new here ... Group: Members Posts: 0 Joined: 14-August 07 From: South Carolina Member No.: 8,000 Region Association: None |
1973 Porsche 914-2.0 for parts or restoration.
Asking $5,000 The Good Orignal 2 liter engine with fuel injection Bosch breakerless ignition modification "Tuna can" extended oil pickup modification Stainless steel heat exchangers Side shift 5 speed transmision 911SC front struts, calipers, vented roters, 5 lug hubs Bilstein shocks 19mm master cylinder Turbo tie rods Heavy duty torsion bars (twenty something) Heavy duty adjustable sway bar Rubber steering joint replaced with plastic Bump steer shims Momo steering wheel Bronze pedal cluster bushings Bilstein rear shocks with adjustable ride height 140 pound springs Heavy duty rear sway bar 914-6 stub axles, 5 lug hubs, roters and calipers The Bad In a word, rust The longs are very bad Sail panels need work Cracks in front inner fender (sway bar mounts) Trunk latch broke (can't open trunk) Engine cover release cable stuck (can't open engine cover) Attached thumbnail(s) |
MikeInMunich |
Oct 2 2020, 08:14 AM
Post
#2
|
Member Group: Members Posts: 392 Joined: 19-November 13 From: Munich, Germany Member No.: 16,674 Region Association: None |
Just for the record here...I would love to have that interior. My brown seats were vandalized, along with by backpad. Some very negative and nasty people out there. It’s sad, but far worse if you make the mistake of marrying one of them. (IMG:style_emoticons/default/headbang.gif)
M.i.M. P.S. as for the car. That’s sad too. (IMG:style_emoticons/default/sad.gif) GLWTS |
dt4 |
Oct 2 2020, 09:11 AM
Post
#3
|
Senior Member Group: Members Posts: 503 Joined: 26-May 19 From: England Member No.: 23,161 Region Association: England |
Id like the interior as well and the engine and the gearbox, struts, calipers, 5 lug hubs etc...
Im trying to make the maths work to buy and ship to the UK but it doesn't sums don't work sadly |
Ferdi911 |
Oct 2 2020, 10:29 AM
Post
#4
|
I'm new here ... Group: Members Posts: 0 Joined: 13-September 20 From: Switzerland Member No.: 24,689 Region Association: None |
PM sent |
phil c |
Oct 2 2020, 12:20 PM
Post
#5
|
Newbie Group: Members Posts: 4 Joined: 29-July 20 From: Okatie SC Member No.: 24,550 Region Association: South East States |
Pm sent
|
914-Kazoo |
Oct 2 2020, 01:52 PM
Post
#6
|
Newbie Group: Members Posts: 45 Joined: 19-August 20 From: Kalamazoo, MI Member No.: 24,609 Region Association: Upper MidWest |
Where is this car located?
|
teds33 |
Oct 2 2020, 02:21 PM
Post
#7
|
I'm new here ... Group: Members Posts: 0 Joined: 14-August 07 From: South Carolina Member No.: 8,000 Region Association: None |
The Car is located in Myrtle Beach, SC. It would have been appropriate to put that in the original post.
I am not parting out the car. I don't have the time, place or energy to take the car apart then dispose of the remains. I'm selling it as a whole. |
anglophone1 |
Oct 2 2020, 03:57 PM
Post
#8
|
Newbie Group: Members Posts: 49 Joined: 30-May 20 From: Ireland Member No.: 24,331 Region Association: None |
Id like the interior as well and the engine and the gearbox, struts, calipers, 5 lug hubs etc... Im trying to make the maths work to buy and ship to the UK but it doesn't sums don't work sadly I just shipped from East Coast US to UK GBP 1185 + 5% duty on total cost+ shipping (c GBP 5200) = GBP 260 - I think thats’s still a deal! Kingstown Shipping |
dt4 |
Oct 3 2020, 01:24 AM
Post
#9
|
Senior Member Group: Members Posts: 503 Joined: 26-May 19 From: England Member No.: 23,161 Region Association: England |
Id like the interior as well and the engine and the gearbox, struts, calipers, 5 lug hubs etc... Im trying to make the maths work to buy and ship to the UK but it doesn't sums don't work sadly I just shipped from East Coast US to UK GBP 1185 + 5% duty on total cost+ shipping (c GBP 5200) = GBP 260 - I think thats’s still a deal! Kingstown Shipping did the same myself 15 months ago. when you add transport to and from the docks there isnt enough value in the parts for me |
Jeans |
Oct 3 2020, 10:03 AM
Post
#10
|
Newbie Group: Members Posts: 5 Joined: 9-August 20 From: Portland, OR Member No.: 24,579 Region Association: Pacific Northwest |
How clean is the gas tank?
How viable is the wiring harness? |
Lo-Fi Version | Time is now: 27th September 2024 - 09:08 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |