Outer CV Joint Reassembly - HELP |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Outer CV Joint Reassembly - HELP |
vesnyder |
Sep 1 2008, 04:58 PM
Post
#1
|
Senior Member Group: Members Posts: 680 Joined: 14-April 05 From: Cleveland, OH Member No.: 3,933 |
I had to remove the rear drivers side trailing arm and thought "while I was in there" I would repack the outer CV Joint. Took it completely apart and cleaned the balls and cage and removed most of the old grease and now I cannot get it back together? What is the trick? Of course I did not mark it to ensure it is assembled the same as it was before - am I screwed? I seem to get it on cock eyed before it goes no farther, then one or more of the ball bearings fall out - help!
This is one dirty job!! |
BMartin914 |
Sep 2 2008, 01:59 PM
Post
#2
|
||| Group: Members Posts: 1,408 Joined: 30-May 04 From: Oregon Member No.: 2,128 Region Association: Pacific Northwest |
Much easier on the bench and much easier to understand how it works once it is off of the car and clean.
|
Lo-Fi Version | Time is now: 27th September 2024 - 01:19 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |