 Electrical Question, Hot in Run and Start? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| andys |
 May 7 2009, 02:59 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,165 Joined: 21-May 03 From: Valencia, CA Member No.: 721 Region Association: None 
 |
On my V8 conversion, I need two hot in run and start +12v sources, but I'm not sure how to determine this from any of the 914 diagrams. I need to power up my PCM, and an Accusump solenoid (or maybe just one hot to activate a relay for both?).
Many thanks, Andys |
   |
 
|
  |
Replies
| SLITS |
May 7 2009, 04:20 PM
Post
#2
|
|
"This Utah shit is HARSH!" Group: Benefactors Posts: 13,602 Joined: 22-February 04 From: SoCal Mountains ... Member No.: 1,696 Region Association: None  |
It is switched power ... on when the key is on ... moving the key to start does not shut the power off on a switched power circuit
You asked for a source of 12 VDC in start only and 2 in run .... I gave you the pinouts for both. |
|
|
|
Posts in this topic
andys Electrical Question May 7 2009, 02:59 PM
SLITS Are you using the 914 relay board or do you want t... May 7 2009, 03:08 PM
andys
Are you using the 914 relay board or do you want ... May 7 2009, 03:27 PM andys
It is switched power ... on when the key is on ..... May 7 2009, 04:30 PM charliew I wouldn't put any other load on the coil circ... May 7 2009, 11:19 PM swl So if you are going to remove the relay board Ron... May 8 2009, 05:40 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th September 2024 - 11:20 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.