Twin plug update, Can i do it. |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Twin plug update, Can i do it. |
904svo |
Mar 22 2010, 06:10 PM
Post
#1
|
904SVO Group: Members Posts: 1,124 Joined: 17-November 05 From: Woodstock,Georgia Member No.: 5,146 |
While trying to make the jigs to drill my heads for twin plugs I ran into a
major problem. Where is the plug going to be located on the bottom of the head. I made up this jig to located where the plug will be located. Angle jig Test jig installed Installed Bottom view |
Katmanken |
Mar 23 2010, 07:10 PM
Post
#2
|
You haven't seen me if anybody asks... Group: Members Posts: 4,738 Joined: 14-June 03 From: USA Member No.: 819 Region Association: Upper MidWest |
It's a little daunting trying to drill two angled holes in each head when each hole is at a different angle to each of the x axis, the y axis and the z axis, and not parallel or perpendicular to anything on the head.
|
904svo |
Mar 23 2010, 09:18 PM
Post
#3
|
904SVO Group: Members Posts: 1,124 Joined: 17-November 05 From: Woodstock,Georgia Member No.: 5,146 |
It's a little daunting trying to drill two angled holes in each head when each hole is at a different angle to each of the x axis, the y axis and the z axis, and not parallel or perpendicular to anything on the head. Thats why I'm making jigs up to locate the holes, and yes it hard to drill the hole but my mill can handle it after I modify it. After I'm done I can modify a good set of heads. |
RJMII |
Mar 23 2010, 09:21 PM
Post
#4
|
Jim McIntosh Group: Members Posts: 3,125 Joined: 11-September 07 From: Sandy, Utah Member No.: 8,112 Region Association: None |
It's a little daunting trying to drill two angled holes in each head when each hole is at a different angle to each of the x axis, the y axis and the z axis, and not parallel or perpendicular to anything on the head. Thats why I'm making jigs up to locate the holes, and yes it hard to drill the hole but my mill can handle it after I modify it. After I'm done I can modify a good set of heads. I hope you're able to figure it out, that's a pretty cool project. not anything i'd use (v6 car here) but it's sure cool to watch your progress. |
Lo-Fi Version | Time is now: 27th September 2024 - 05:30 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |