 WEBER 44 IDF REBUILDS |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jom |
 Apr 21 2004, 10:46 AM
Post
#1
|
|
Newbie  Group: Members Posts: 22 Joined: 18-September 03 From: new jersey Member No.: 1,173  |
I have a set of weber 44 idfs that need to be rebuilt and have a few questions.
1. where the throttle shaft meets the throttle plates is slight corosion on one carb what is the best way to remove the screws holding the plates on. drill? grind? any recomendations. 2. what is the best way to remove the choke tubes and aux. venturis? currently i am running a 1.8 with L-jet F.I. and will keep it as long as it holds up. Not sure what I am going to do with the carbs but figured i would rebuild them because they were laying around. Figured if i ever build a larger motor iwould use them. |
   |
 
|
Posts in this topic
  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th September 2024 - 04:20 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.