Bolt application, Question |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Bolt application, Question |
Randal |
Jan 31 2013, 02:29 PM
Post
#1
|
Advanced Member Group: Members Posts: 4,446 Joined: 29-May 03 From: Los Altos, CA Member No.: 750 |
I've been looking for a button head cap screw that I could use with Gotti 3 piece wheels. The screw has to able to take 14 foot pounds of torque (168 inch pounds), so the normal versions you can find break. By switching to socket head cap screws the torque issue.s goes away, but socket heads have a higher profile than I would like. I know the Gotti folks sell, for about a buck apiece, the button heads that will take the torque, but would like to find a US supplier. Need M6 x 35mm. |
Harpo |
Jan 31 2013, 04:33 PM
Post
#2
|
Senior Member Group: Members Posts: 1,304 Joined: 21-August 11 From: Motor City aka Detroit Member No.: 13,469 Region Association: None |
Because of the federal Fastener Act all fasteners are required to have a head marking. If you can show me the head marking I can tell you who made it so you can go to the source.
ARP might have something also If you can get a photo send me a PM in case I don't see your posting here. DAvid |
Lo-Fi Version | Time is now: 27th September 2024 - 09:13 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |