Problem installing Polybronze bushing, Bushing not fitting |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Problem installing Polybronze bushing, Bushing not fitting |
skeates |
Mar 6 2013, 10:16 PM
Post
#1
|
Member Group: Members Posts: 218 Joined: 28-February 05 From: Sacramento, ca Member No.: 3,684 Region Association: Northern California |
Hey guys, I've been putting together my set of Elephant Racing bushings for the front control arms, but seem to have run into a bit of a problem...
The bushing went into the front mounts without any problems (only needed the 100-150 lbs of force mentioned in the instructions). However, where they go into the rear mounts the fit is significantly tighter! For one I couldn't start it by hand like the fronts, and it definitely took more more effort on the vice to push in. The bushing seated...mostly, but now I'm noticing a bulge in the red poyl material and the busing won't seat any further into the mount (see pics below). I never measured the interference on the fronts, but I'm seeing somewhere close to 4 one-hundredths interference for the rear. Am I missing something here? I was thinking about using a torch to gently heat the mount it get it to expand a bit but I am worried that doing so could/will ruin the busing. Anyone else run into this problem before? |
skeates |
Mar 6 2013, 10:41 PM
Post
#2
|
Member Group: Members Posts: 218 Joined: 28-February 05 From: Sacramento, ca Member No.: 3,684 Region Association: Northern California |
Well, I suppose I'm relieved that I'm not the only one who's had this problem (IMG:style_emoticons/default/smile.gif)
When you say "several attempts" does that mean that you removed the bushing and then re-seated it, or do you mean that you rotated the whole assembly and then pressed again? I think that it may be a wee bit crooked, but not too much. In the vice I can get the bronze flange flush with the mount. but as soon as I relieve the pressure the bushing seems to pop back out to what you see in the above pics. Maybe I just need to keep at it? |
Lo-Fi Version | Time is now: 26th September 2024 - 06:26 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |