 Interesting Items, Any Ideas? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mblizzard |
 Sep 23 2013, 11:08 AM
Post
#1
|
|
Advanced Member  Group: Members Posts: 3,033 Joined: 28-January 13 From: Knoxville Tn Member No.: 15,438 Region Association: South East States  |
There have been a few items that I have encountered recently that just seemed very expensive for what they were. Getting closer to potentially getting them to a much cheaper price.
 |
   |
 
|
  |
Replies
| rhodyguy |
Sep 23 2013, 04:05 PM
Post
#2
|
|
Chimp Sanctuary NW. Check it out. Group: Members Posts: 22,188 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch |
what are they made of? can the material handle a flash back thru the carbs?
|
|
|
|
Posts in this topic
Mblizzard Interesting Items Sep 23 2013, 11:08 AM
Dave_Darling Front suspension bushing?
--DD Sep 23 2013, 03:08 PM Mblizzard 3-D printed Venturi's.
Thoughts? Sep 23 2013, 03:23 PM codices These are tools for removal and replacement of sma... Sep 23 2013, 03:58 PM Mblizzard Kevin they should be fine as the are high temp PLA... Sep 23 2013, 06:36 PM r_towle Cool.
What materials can you print?
I would be in... Sep 23 2013, 06:41 PM Mblizzard For the velocity stacks I would go with ABS lower ... Sep 23 2013, 06:48 PM r_towle Is it just plastic? Sep 23 2013, 06:49 PM
Eric_Shea
Is it just plastic?
Factory used plastic stacks... Sep 23 2013, 07:15 PM Mblizzard Yep but it has an additional solvent resistant coa... Sep 23 2013, 06:59 PM bulitt If I could offer a request, and don't know wha... Sep 23 2013, 07:12 PM Mblizzard
If I could offer a request, and don't know wh... Sep 23 2013, 07:31 PM r_towle Questin is really, can you only print plastic? Sep 23 2013, 07:29 PM Mblizzard
Questin is really, can you only print plastic?
... Sep 23 2013, 07:52 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th September 2024 - 11:14 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.