On Topic - Anyone remember reading about, Type IV push rod tube mod. Options

[SpecialK]

I can't remember where I read it, and it was several years ago, but someone did a mod on their push rod tubes in an effort to keep the crankcase oil from sloshing into the heads on hard cornering. I think it had something to do with attaching the end of a Type I PR tube to the "case side" of a T4 tube which made it extend farther into the case. This supposedly prevented (to a certain extent) as much oil from entering the heads during a hard cornering, yet still allowed the heads to drain normally.

Anyone heard of, or done this?

[SpecialK]

"Anything you do to the PR tube to retain slosh will also retain oil IN THE TUBES thus keeping it from the SUMP where it can be picked up again and recirculated."


"I make tabs that weld to the pick up tube and retain slosh and they work well. I have tubes with these welded on already if anyone wants to try one and see the differences.."

So, which is it Jake? (IMG:style_emoticons/default/confused24.gif)

Quote #1 is referring to the Pushrod Tubes. Quote #2 is referring to the Pick Up Tube.

Ooops.... (IMG:style_emoticons/default/slap.gif)