 Weber Carb Hex Bar Linkage, which way around should I go? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jandro62 |
 Jan 2 2005, 05:50 PM
Post
#1
|
|
Member  Group: Members Posts: 104 Joined: 4-June 04 From: Texas Member No.: 2,156  |
I'm using the Weber Redline hex bar kit
Should the hex bar go towards the front of the car or towards the rear? So i've been digging through old posts, and it appears that people have done both. It seems like going towards the front of the car puts it close to stuff like the dizzy etc, but with plenty of room towards the rear. Any thoughts? |
   |
 
|
  |
Replies
| Jake Raby |
Jan 3 2005, 11:41 AM
Post
#2
|
|
Engine Surgeon Group: Members Posts: 9,398 Joined: 31-August 03 From: Lost Member No.: 1,095 Region Association: South East States |
CB linkage is awesome... For a Hex Bar.
Its what I use specifcally. There are others, but the only center pull arrangement that I have used was hard to adjust and the installer normally needed hand holding and a call to me to get it right- Thats not cool. I avoid the damn phone at all costs! |
|
|
|
Posts in this topic
jandro62 Weber Carb Hex Bar Linkage Jan 2 2005, 05:50 PM
synthesisdv most run it forward which makes it easy for runnin... Jan 2 2005, 06:05 PM jwalters http://www.914world.com/bbs2/html/e... Jan 2 2005, 06:06 PM Joe Sharp Old I like the hex bar, been using it for 20 years on ... Jan 2 2005, 06:15 PM URY914 Sorry, but the center pivot is Mickey Mouse.
Hex ... Jan 2 2005, 06:16 PM Joe Sharp Old Sorry I frogot the pic Jan 2 2005, 06:16 PM Joe Sharp Old Oh yeah. the stock cable worked out but I had to b... Jan 2 2005, 06:19 PM Kargeek Mine point to the rear, however depending on the h... Jan 2 2005, 06:54 PM SirAndy here's mine. stock cable. works great! Jan 2 2005, 07:23 PM bwilless The big problem with the center piviot steup is th... Jan 2 2005, 07:33 PM jandro62 well it looks like this install won't be any d... Jan 2 2005, 07:58 PM JOHNMAN I used to run with the hex bar linkage. At the ti... Jan 2 2005, 10:42 PM
Aaron Cox ... Jan 3 2005, 11:46 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th September 2024 - 03:26 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.