Replacing fuel lines |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Replacing fuel lines |
aeginc77 |
Jul 21 2023, 09:59 AM
Post
#1
|
Newbie Group: Members Posts: 19 Joined: 29-April 15 From: United States Member No.: 18,682 Region Association: None |
I can't be the only owner of a 914 that has had deteriorating rubber fuel lines but I can't seem to find the right posts covering this. Basically the fabric covered rubber fuel lines seem to deteriorate and split probably as a result of the ethanol in the fuel. Does anyone know if there are any replacements that hold up with the ethanol fuel. I ordered a new 7mm line from Pelican Parts and it seems to be the same German fabric covered rubber that was originally installed.
|
second wind |
Jul 21 2023, 06:08 PM
Post
#2
|
Senior Member Group: Members Posts: 860 Joined: 30-December 10 From: Los Angeles, California Member No.: 12,543 Region Association: Southern California |
OK....I just went through this....when I would head out to the car and see a puddle of gas under it it kinda' ruined my mood to even start the car let alone go on a drive. I used the fabric covered lines to be correct and "european" but the ethanol in Los Angeles chews them right up. The fix is using R30 9 fuel line from Gates or Continental.....Cadna 50087 is the Continental brand at advanced auto parts....what a difference!!!! Good luck....doing all of the work under the car left me with a stiff neck...took two months...no leaks now though....Euro trash !!!
gg |
aeginc77 |
Jul 26 2023, 07:37 AM
Post
#3
|
Newbie Group: Members Posts: 19 Joined: 29-April 15 From: United States Member No.: 18,682 Region Association: None |
OK....I just went through this....when I would head out to the car and see a puddle of gas under it it kinda' ruined my mood to even start the car let alone go on a drive. I used the fabric covered lines to be correct and "european" but the ethanol in Los Angeles chews them right up. The fix is using R30 9 fuel line from Gates or Continental.....Cadna 50087 is the Continental brand at advanced auto parts....what a difference!!!! Good luck....doing all of the work under the car left me with a stiff neck...took two months...no leaks now though....Euro trash !!! gg I think I am facing replacing all the lines. Did you have to remove the fuel tank to get to the hoses that go into the tank. My 914 is a 1975 so the fuel pump is in the front trunk but I think I still need to remove the tank to access the hoses. There is a small access plate under the car but it doen't look big enough to easily change hoses. Your thoughts? Alan |
VaccaRabite |
Jul 26 2023, 08:32 AM
Post
#4
|
En Garde! Group: Admin Posts: 13,554 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region |
I think I am facing replacing all the lines. Did you have to remove the fuel tank to get to the hoses that go into the tank. My 914 is a 1975 so the fuel pump is in the front trunk but I think I still need to remove the tank to access the hoses. There is a small access plate under the car but it doen't look big enough to easily change hoses. Your thoughts? Alan Yes, you want to pull the tank out. Its not that much effort. On my tank I put a molex connector on the three wires that go to the gas gauge sender so I can just unplug that rather then un-bolt the filler and all that jazz. Once the tank is drained (which I do by siphoning out the top) its only about 15 minutes to pull out the tank. Zach |
Lo-Fi Version | Time is now: 27th September 2024 - 10:06 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |