 Stuck Oil Pressure Relief Piston, small one.... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Aaron Cox |
 Mar 18 2005, 09:37 PM
Post
#1
|
|
Professional Lawn Dart  Group: Retired Admin Posts: 24,541 Joined: 1-February 03 From: OC Member No.: 219 Region Association: Southern California  |
any ideas how to get this out?
Steve stromberg had a few good ideas: we tried cranking the motor with plugs out...and making the oil pressure push it out- No Go... tried a magnet - No Go i guess im down to an EZ out... (IMG:http://www.914world.com/bbs2/html/emoticons/sad.gif) |
   |
 
|
  |
Replies
| skline |
Mar 18 2005, 09:55 PM
Post
#2
|
|
Born to Drive Group: Members Posts: 7,910 Joined: 26-December 02 From: Costa Mesa, CA Member No.: 17 Region Association: Southern California |
Ok, Sorry Aaron, I will be nice now. It did make me laugh though. If you are replacing the piston, you can drill a 1/8 hole in the center and then put a screw part way in and then you will have something to pull on. Did you try that? Dont give up now, its not even 9 yet.
|
|
|
|
Posts in this topic
Aaron Cox Stuck Oil Pressure Relief Piston Mar 18 2005, 09:37 PM
scott thacher okay at this point it is either oil varnish or it ... Mar 18 2005, 09:45 PM Aaron Cox spent 4 hours wrestling with it..... http://w... Mar 18 2005, 09:52 PM Aaron Cox Mar 18 2005, 09:59 PM JOHNMAN IIRC, the oil relief pistons have a round recess i... Mar 18 2005, 10:29 PM Paul Illick On T1 engines the inside of the piston is just a b... Mar 19 2005, 05:27 AM ArtechnikA assuming you're going to replace the piston an... Mar 19 2005, 06:00 AM skline My suggestion to drill it and screw in a screw to ... Mar 19 2005, 07:43 AM V6914 You could use a piston relief puller, vw same thin... Mar 19 2005, 11:18 AM
brp914 Curious - Is this a running engine? How did you c... Mar 19 2005, 12:42 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th September 2024 - 08:57 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.