 Jack Points |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| HalM |
 Sep 14 2007, 05:49 PM
Post
#1
|
|
Green Skull 003  Group: Members Posts: 127 Joined: 19-January 05 From: The 'Burg Member No.: 3,472 Region Association: None  |
I need to use my floor jack and remove my wheels. The normal jack tubes are rusted out and due to be replaced shortly. In the interim, where under the car can I place the jack and not hurt anything?
Thanks, Hal Michael '73 914 2056 RAT '96 993 |
   |
 
|
  |
Replies
| orthobiz |
Sep 14 2007, 11:25 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,757 Joined: 8-January 07 From: Cadillac, Michigan Member No.: 7,438 Region Association: Upper MidWest 
|
Found some pics where I have jacked and supported my car: the hydraulic jacks are using the donuts in the front. I used stands on the torsion bar supports, but I guess you could jack there as well.
Oh yeah, got rid of my ratchet style stands in favor of the pin style thanks to Gint! Paul Attached image(s)      
|
|
|
|
Posts in this topic
HalM Jack Points Sep 14 2007, 05:49 PM
RoninEclipse2G Unfortunatly I don't have acess to a cam to ta... Sep 14 2007, 07:00 PM swl just be careful with the jacking donuts - they can... Sep 14 2007, 07:15 PM
RoninEclipse2G
just be careful with the jacking donuts - they ca... Sep 15 2007, 09:17 AM swl OK - confession time. Looking for a slap if this ... Sep 15 2007, 06:39 AM HalM Thanks for the help everyone. Much appreciated... Sep 15 2007, 06:44 AM So.Cal.914
Probably a good idea. Sep 15 2007, 06:55 AM thomasotten Jacking by the tranny or engine can cause the rubb... Sep 15 2007, 07:15 AM Mountain914 Does this help ? I think I got it from Damp Dave,... Sep 15 2007, 11:19 PM Dave_Darling On those long areas, make sure you use a board to ... Sep 16 2007, 01:59 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th September 2024 - 01:21 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.