Jenvey TB linkage install question |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Jenvey TB linkage install question |
rtalich |
Sep 21 2007, 09:41 PM
Post
#1
|
Member Group: Members Posts: 279 Joined: 25-September 06 From: Bellevue, WA Member No.: 6,913 Region Association: None |
Installing some Jenvey TB's and have run into a bit of a problem. The linkage rods are too short. It never reaches full throttle with rods adjusted at full length. I have a few ideas as to what to try, but wanted to see if anyone else has had this problem and what was done to fix it.
Thanks, Rob |
Mark Henry |
Sep 21 2007, 11:19 PM
Post
#2
|
that's what I do! Group: Members Posts: 20,065 Joined: 27-December 02 From: Port Hope, Ontario Member No.: 26 Region Association: Canada |
Redrill the little arms on the carbs to shorten the throw.
Both Jake and I have used a center pull linkage. |
Lo-Fi Version | Time is now: 27th September 2024 - 01:50 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |