Drilling for 10mm Roll Pins On New CV Joint., Use a drill bit or have it machined out. |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Drilling for 10mm Roll Pins On New CV Joint., Use a drill bit or have it machined out. |
tach |
Sep 6 2015, 12:56 PM
Post
#1
|
Member Group: Members Posts: 79 Joined: 6-November 09 From: Minnesota Member No.: 11,016 Region Association: Upper MidWest |
I ordered new VW type 1 lobro cv joints for my 914 but the 2 roll pin holes need to be bored out to 10mm X 20mm deep. I was wondering if I can just bore out the hole on my drill press with a 10mm drill bit or do I need to have the hole machine larger with a end mill by a machine shop?
|
Lo-Fi Version | Time is now: 27th September 2024 - 06:19 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |