 Outer CV Joint Reassembly - HELP |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| vesnyder |
 Sep 1 2008, 04:58 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 680 Joined: 14-April 05 From: Cleveland, OH Member No.: 3,933  |
I had to remove the rear drivers side trailing arm and thought "while I was in there" I would repack the outer CV Joint. Took it completely apart and cleaned the balls and cage and removed most of the old grease and now I cannot get it back together? What is the trick? Of course I did not mark it to ensure it is assembled the same as it was before - am I screwed? I seem to get it on cock eyed before it goes no farther, then one or more of the ball bearings fall out - help!
This is one dirty job!! |
   |
 
|
Posts in this topic
vesnyder Outer CV Joint Reassembly - HELP Sep 1 2008, 04:58 PM
Bartlett 914 There are only 2 ways they go together. One is wro... Sep 1 2008, 05:19 PM vesnyder I found this link on the 911 board I visit, should... Sep 1 2008, 05:34 PM Eric_Shea I found this link on the 914 board I visit, should... Sep 1 2008, 06:21 PM
Gint
I found this link on the 914 board I visit, shoul... Sep 2 2008, 05:03 PM wertygrog it's hard to explain, but you need to get two ... Sep 2 2008, 12:58 AM BMartin914 It is not hard to explain.
You have wide spaces ... Sep 2 2008, 07:51 AM vesnyder Ben - Thanks. Looks like may have been assembled ... Sep 2 2008, 10:21 AM BMartin914 Much easier on the bench and much easier to unders... Sep 2 2008, 01:59 PM vesnyder I was working on the outer CV joint and when I rem... Sep 2 2008, 02:58 PM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th September 2024 - 09:52 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.