 944 CV bolt to 71 911 stub axle? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| John |
 Feb 5 2008, 04:32 PM
Post
#21
|
|
member? what's a member?  Group: Members Posts: 3,393 Joined: 30-January 04 From: Evansville, IN (SIRPCA) Member No.: 1,615 Region Association: None  |
QUOTE(ClayPerrine @ Feb 5 2008, 12:43 PM)  I use late model 911 hubs and 944 stub axles. Both are easy to find, and will work together if you cut down the hub to fit the bearing. Just chuck them up in a lathe and cut them the same length as the 944 hub's bearing surface. They are cheaper too.... Wouldn't that put the wheel flange about 10mm closer to the trailing arm? The later model (aluminum trailing arm era) 911 rear hubs used a 10mm wider bearing and the hubs were just cut deeper to accommodate the 10mm wider bearing. I have used a spacer to make up for the more narrow 914 bearings. That places the face of the 911 hub back to the original position. The later 911 rear hubs had a centering ring of sorts while the earlier ones did not. As far as I know, both ways work equally well once set up. |
   |
 
|
|
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 24th November 2024 - 05:59 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.