 My low buck homemade /6 engine stand, turning a cheap china bug mount into a cheap Canadian mount |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| Mark Henry |
 Dec 20 2010, 10:53 PM
Post
#1
|
|
that's what I do!  Group: Members Posts: 20,065 Joined: 27-December 02 From: Port Hope, Ontario Member No.: 26 Region Association: Canada  |
I'm too cheap to buy a new stand, so I spent 4 hours today modifiing my cheap china bug mount.
I had everything and the mount was given to me so my total investmeny so far is $0. OK I lied the gas and mig wire must of cost me a couple of bucks. Mike Galloway gave me the 1/4" plate cut with the proper radius, was given the cheapo mount by another guy few years ago, the small pipe is 3/4" gas pipe and the heavy tube my brother gave me 20+ years ago. Sorry about the crappy welds. my little mig welder needs a new liner and I only have a cheap handheld eye shield as I busted my helmet. Hey I said I was cheap (IMG:style_emoticons/default/biggrin.gif) Tomorrow I'll do some work on the homemade stand I have. Attached image(s)  
|
   |
 
|
| Mark Henry |
Dec 20 2010, 11:04 PM
Post
#2
|
|
that's what I do! Group: Members Posts: 20,065 Joined: 27-December 02 From: Port Hope, Ontario Member No.: 26 Region Association: Canada |
My buddy said the original center tube would be just fine, but I was a little nervous about hanging a heavy SC engine out on. I went with something thicker, I thing it's the right decision.
I cheap...not stupid (IMG:style_emoticons/default/biggrin.gif) Attached image(s) 
|
|
|
|
| wobbletop |
Dec 21 2010, 12:13 PM
Post
#3
|
|
Member Group: Members Posts: 382 Joined: 8-December 06 From: Ontario, Canada Member No.: 7,335 Region Association: Canada |
Nice job, Mark.
You must be loving the lift too! |
|
|
|
|
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 07:50 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.