 Spindle location? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| slugmika |
 Mar 5 2006, 02:08 PM
Post
#1
|
|
Member  Group: Members Posts: 208 Joined: 19-February 03 From: Finland Member No.: 318  |
Is spindle in a same line as the balljoint? i'am putting the front axle to right wheel base and was wondering if i could take the measure from baljoint?
Mika |
   |
 
|
| sixnotfour |
Mar 5 2006, 02:12 PM
Post
#2
|
|
914 Wizard Group: Members Posts: 10,678 Joined: 12-September 04 From: Life Elevated..planet UT. Member No.: 2,744 Region Association: Rocky Mountains 
|
Due to castor angle ,the spindle is behind the ball joint.
|
 |
|
| slugmika |
Mar 6 2006, 04:53 AM
Post
#3
|
|
Member Group: Members Posts: 208 Joined: 19-February 03 From: Finland Member No.: 318 |
yes, factory castor is 6' but is the spinle in a center line of strut tube? Oh well, today i'll have change to measure that from original strut.
Thanks Mika |
|
|
|
| ChrisFoley |
Mar 6 2006, 06:40 AM
Post
#4
|
|
I am Tangerine Racing Group: Members Posts: 7,968 Joined: 29-January 03 From: Bolton, CT Member No.: 209 Region Association: None
|
The spindle is on the centerline of the strut tube, at an angle of 79.5 degrees (10.5 below perpendicular) if I'm not mistaken.
|
|
|
|
| slugmika |
Mar 6 2006, 09:54 AM
Post
#5
|
|
Member Group: Members Posts: 208 Joined: 19-February 03 From: Finland Member No.: 318 |
thanks Chris
I'll attach my front axle to chassis table today. What do you say about front axle? should i put height in a factory settings which is 9cm from torsion bar center to ball joint? I'am going to raise the spindle 25mm and was thinking about raising whole front suspension by 25mm. Mika |
|
|
|
| ChrisFoley |
Mar 6 2006, 07:15 PM
Post
#6
|
|
I am Tangerine Racing Group: Members Posts: 7,968 Joined: 29-January 03 From: Bolton, CT Member No.: 209 Region Association: None
|
9cm is way too much. 3-4cm should be plenty. Raising both the spindle and pickups by 25mm is good.
|
|
|
|
|
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 08:34 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.