 ATTN: ENGINE MOUNT REPLACEMENT |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| bd1308 |
 Dec 13 2006, 01:18 AM
Post
#1
|
|
Sir Post-a-lot  Group: Members Posts: 8,020 Joined: 24-January 05 From: Louisville,KY Member No.: 3,501  |
I encountered a little mishap at the FFC this past year which bent the bolt that mounts the engine to the mount, which is nothing more than a piece of U channel with holes drilled in the right places. I assume I need four 911 sport mounts in order to recify this situation, which will cost on the order of 80+ dollars, just for mounts?
ANybody seen the U channel engine mount mod? |
   |
 
|
| Dave_Darling |
Dec 13 2006, 02:20 AM
Post
#2
|
|
914 Idiot Group: Members Posts: 15,063 Joined: 9-January 03 From: Silicon Valley / Kailua-Kona Member No.: 121 Region Association: Northern California 
|
Assuming you have a side-shifter and not a tail-shifter, the U-channel things are the stock parts. The 911 sport mounts will, if you install them the "regular" way, make the engine hang down too low and you will have problems shifting.
Clay tells me you can put the rubber mounts in upside-down and have things line up. But you'll have rubber mounts in the center (between the motor and the bar) and at the outer end (between the bar and the chassis) which would seem to be too much looseness. I recommend getting the correct U-channel pieces from Pelican. Failing that, make 'em yourself out of U-channel that you absolutely know for certain is strong enough. --DD |
|
|
|
| jr91472 |
Dec 13 2006, 07:16 AM
Post
#3
|
|
"I'm pacing myself sergeant..." Group: Members Posts: 1,205 Joined: 2-August 04 From: McKinney, TX Member No.: 2,437 |
Are you talking about the bracket that mounts to the center of the "old" tailshifter mounting bar?
If so, I have one that you can have. Let me know. |
|
|
|
|
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd December 2024 - 05:42 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.