 Crankshaft endplay |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jmargush |
 Mar 23 2013, 03:59 PM
Post
#1
|
|
Member  Group: Members Posts: 465 Joined: 8-June 04 From: Goshen, IN Member No.: 2,176  |
I just put my case halves together and after I got everything torqued down I checked the crank and it it spins free.
However the end play seems a little excessive. Haven't measured it yet but guess is it is atleast .125" Is this due to the distributor drive not being installed yet and/or the flywheel not installed yet either? Just nervous as this is the first time at building one up. |
   |
 
|
  |
Replies(1 - 5)
| AE354803 |
Mar 23 2013, 04:19 PM
Post
#2
|
|
Member Group: Members Posts: 232 Joined: 13-August 12 From: Southern California Member No.: 14,801 Region Association: Southern California |
Flywheel has to be installed, you adjust the shims between the flywheel and the crank until you get end play of 0.003-0.005" or do math, install only the two thicker shims and figure out what size to put in to bring you to 0.003-0.005, then reinstall and measure |
|
|
|
| mrbubblehead |
Mar 23 2013, 05:04 PM
Post
#3
|
|
Twodollardoug Group: Members Posts: 1,155 Joined: 17-December 10 From: calimesa ca. Member No.: 12,492 Region Association: Southern California |
your fine, carry on.
|
|
|
|
| Mark Henry |
Mar 23 2013, 07:16 PM
Post
#4
|
|
that's what I do! Group: Members Posts: 20,065 Joined: 27-December 02 From: Port Hope, Ontario Member No.: 26 Region Association: Canada |
At this point you should have 2 shims (to measure end play, no seal in yet) and flywheel temporarily in place.
|
|
|
|
| jmargush |
Mar 24 2013, 05:55 AM
Post
#5
|
|
Member Group: Members Posts: 465 Joined: 8-June 04 From: Goshen, IN Member No.: 2,176 |
Thanks guys!
|
|
|
|
| eyesright |
Mar 24 2013, 07:18 AM
Post
#6
|
|
Member Group: Members Posts: 430 Joined: 8-January 12 From: OK Member No.: 13,979 Region Association: Southwest Region |
I just put in my first rebuild too. I decided whattheheck, just put the three shims/spacers in that came off on the tear down and see how close that is, nothingtolose since if you start with the two shims you usually have to add a third anyway. ...Dial indicator showed it was right at .004. I got lucky.
You're right, there sure is a lot of slop before you put the flywheel on. I'll try to start it this week. Good luck on yours. |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 06:53 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.