Correct size oil line for /6 racecar |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Correct size oil line for /6 racecar |
GaroldShaffer |
Apr 22 2008, 10:58 PM
Post
#1
|
You bought another 914? Group: Benefactors Posts: 7,627 Joined: 27-June 03 From: Portage, IN Member No.: 865 Region Association: None |
Most of you know I bought an old FP racer last fall. The car was setup with a dry sump system for /4 engine. It now has a nice 2.4 /6 in it, but there are some concerns that the oil lines are to small for the amount of oil needed for the /6 engine.
I know its not going to be cheap to replace all the braided oil lines, but I want to make sure this is done right and not F up my /6 engine. So what is the proper size oil line needed? AN-12 or AN-16? I think what is in there now is AN10. Also I assume I will need a higher capacity oil tank (16 quart) since I think the one in there now is not a 16 quart one. Yes? I have been on the PMS website and tanks are $421 (IMG:style_emoticons/default/blink.gif) and hose is $10 - $11 perfoot, plus I will need fittings also. Needless to say, I will be driving my other 914 for a while. |
jcd914 |
Apr 23 2008, 12:23 AM
Post
#2
|
Advanced Member Group: Members Posts: 2,081 Joined: 7-February 08 From: Sacramento, CA Member No.: 8,684 Region Association: Northern California |
Garold, To and from your oil cooler -12 will be fine. From the oil tank to the engine at least -16. Where is your oil tank? On Ron's 914 race car we ran -20 line from the tank in the front trunk to the engine but then we were feeding a 3.4L monster 6. You probably don't need a bigger tank with a 2.4L engine. The need for more oil is tied to the heat generated by the engine, 2.4 won't need 16 quart capacity. Get the old tank cleaned though. Andy, Nice lines! Must have been much easier to work with than braided steel. Jim |
ArtechnikA |
Apr 23 2008, 07:29 PM
Post
#3
|
rich herzog Group: Members Posts: 7,390 Joined: 4-April 03 From: Salted Roads, PA Member No.: 513 Region Association: None |
From the oil tank to the engine at least -16. You can cut a corner here or there on the scavenge system as it is quite forgiving; you collapse a supply line and your bearings will let you know in a hurry. |
Lo-Fi Version | Time is now: 24th September 2024 - 01:05 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |