 how do you remove front targa roll bar pad? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rfuerst911sc |
 Nov 8 2008, 01:41 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,158 Joined: 4-May 06 From: Dahlonega , Georgia Member No.: 5,980 Region Association: South East States  |
I'm getting my car stripped down to get ready for paint (IMG:style_emoticons/default/piratenanner.gif) Today I removed the targa roof and removed all the side weatherstripping and pads on the targa bar and removed the back glass. But when I went to remove the front targa pad I couldn't get it off (IMG:style_emoticons/default/sad.gif) I removed 10 ( I think ) screw caps 5 on the bottom and 5 on the front. I then removed 5 screws on the bottom but couldn't seem to get a phillips screwdriver to engage the screws in the front of the pad. Are there phillips screws in there? I assume the pad comes off and the rear targa latches stay in place?
|
   |
 
|
  |
Replies
| rfuerst911sc |
Nov 9 2008, 02:12 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 2,158 Joined: 4-May 06 From: Dahlonega , Georgia Member No.: 5,980 Region Association: South East States |
Well the good news is I got the pad off (IMG:style_emoticons/default/piratenanner.gif) The bad news is it is now toast (IMG:style_emoticons/default/sad.gif) It wasn't in great shape to begin with and some angry twisting,swearing didn't help it any (IMG:style_emoticons/default/biggrin.gif) So I guess I now need another (IMG:style_emoticons/default/blink.gif) That will wait until after the repaint. I think when I do get another pad I may slide some small tubes in the holes and clean out any foam that is obstructing the view of the screwheads. (IMG:style_emoticons/default/beerchug.gif)
|
|
|
|
Posts in this topic
rfuerst911sc how do you remove front targa roll bar pad? Nov 8 2008, 01:41 PM
SLITS Nobody ever said that they installed the screws in... Nov 8 2008, 01:48 PM
Dave_Darling There are also a couple of screws that hold the ta... Nov 9 2008, 11:58 AM dgw I used a lot of four letter words, and walked away... Nov 8 2008, 03:28 PM rfuerst911sc Thanks guys. Nov 9 2008, 06:00 AM Lou W
Well the good news is I got the pad off :Qarl: ... Nov 9 2008, 02:46 PM Todd Enlund Plasma cutter. Nov 9 2008, 02:53 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th June 2024 - 11:18 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.