 Was Balancing Question...now some other questions, Questions are last post, hilfe bitte. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| stephenaki |
  Feb 6 2009, 07:09 AM
Post
#1
|
|
Can I get this one dad??  Group: Members Posts: 1,183 Joined: 11-August 07 From: Palmetto, FL Member No.: 7,987 Region Association: None  |
OK, I have a tendency to move faster than I think, amazing I got this far in life. I was reading the assembly procedures for the clutch and clutch pressure plate, as I read it talked about marking the position of the pressure plate in relation to the flywheel in order to maintain the balance. DAMNIT! Yup you guessed it I didn't do that. Primarily because I haven't had to do it with the standard block engines I have worked on before.
So, is there a way to remedy this mistake or am I just kinda hosed and, how much of a difference will it make since the rest of the motor was balanced? |
   |
 
|
  |
Replies
| stephenaki |
Feb 8 2009, 01:18 PM
Post
#2
|
|
Can I get this one dad?? Group: Members Posts: 1,183 Joined: 11-August 07 From: Palmetto, FL Member No.: 7,987 Region Association: None |
Thanks all, I am assuming by the lack of additional posts that your observations are correct. I feel a bit better now.
Unfortunately, I didn't get to work on the motor this weekend as I am still waiting on my dial gauge and some other parts. I did clean up the distributor and the coil though so all was not totally lost. Also got my aquabox mounted on my motorcycle for my GPS along with the powerlett setup to power the GPS when I am on the road in May. Hopefully I get the dial gauge in this week so I can continue my progress on the motor. |
|
|
|
Posts in this topic
stephenaki Was Balancing Question...now some other questions Feb 6 2009, 07:09 AM
So.Cal.914 I am not sure what engine this is but the PP shoul... Feb 6 2009, 07:21 AM smdubovsky I don't think it makes a difference. My crank... Feb 6 2009, 08:22 AM Mark Henry Most good balance jobs PP to flywheel orientation ... Feb 9 2009, 07:00 AM stephenaki No, "0" that I can find. Next question,... Feb 13 2009, 08:51 AM SLITS The question of balancing the clutch assembly with... Feb 13 2009, 08:54 PM
stephenaki
The question of balancing the clutch assembly wit... Feb 14 2009, 10:29 AM hcdmueller The oil strainer is listed at 9 ft/lbs in my bus b... Feb 14 2009, 10:45 AM stephenaki
The oil strainer is listed at 9 ft/lbs in my bus ... Feb 14 2009, 12:01 PM Jake Raby Yes, it makes a difference. Having balanced hundre... Feb 14 2009, 11:34 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st October 2024 - 07:22 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.