Anybody out there getting ready to assemble, I'll need help figuring out the steps Options

[PanelBilly]

The paint is DONE. I resanded down the inside of tha sail panels and got them re-painted today. Well, I need to wait a few weeks for the paint to cure enough to buff, but everything looks right this time.

I'm eager to start planning the reassembly. It been a few years since I tore the car down and all the photos I took to document the process were "lost" in the divorce. I figure there needs to be a plan and if anybody out there is a few steps ahead of me or remembers the sequence from a project they finished, I could use some help.

I'm thinking I should start with the wiring that runs in the tunnel. But what's next?

[Gint]

(IMG:style_emoticons/default/agree.gif) to a degree, however... plan schman.... you don't need a plan. Just do it! (IMG:style_emoticons/default/laugh.gif) I'm laughing because I can't take my own advice.

Wiring harness and tunnel first as Zach suggested. From there it depends on what is ready and what isn't. If the motor is in pieces, what's the point of doing the engine compartment? I'm going to do the suspension first so the car will be finished underneath and can be rolled around. From there I think I'll work on the steering, dash and front trunk dash components. Then... and on and on.