Finally - finished my dash, All SS now! |
|
Wednesday, 22 January 2025 |
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Finally - finished my dash, All SS now! |
Engman |
Jul 6 2009, 01:44 PM
Post
#1
|
Zoisite Group: Benefactors Posts: 1,349 Joined: 25-March 03 From: New Albany, IN Member No.: 475 |
Finally finished up the dash in brushed stainless steel. I am very pleased with the outcome!
Attached image(s) |
r_towle |
Jul 6 2009, 05:45 PM
Post
#2
|
Custom Member Group: Members Posts: 24,705 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States |
very nice looking.
Stainless console....just thinking outloud. I have three things I would like to see what it might cost... Could be longer term products. First How hard would it be for you to do 2.0 liter HE flanges in soft steel, not stainless? I know you have the program already. I need to weld these myself with no tig....so mig will be my weapon of choice. Second Weber 40mm IDF top of carb...a 1/2 thick plate...two holes ( I will provide you the diameter for the stacks I have) plus a butterfly hole for the jet tubes....and the screw holes to hold it all down ( I could do those if needed...) And finally. a 1/2 inch thick piece of aluminum that is for the oil filler tower. Remove the tower/filler. The piece would fit over the rectangular opening. It would have a groove in the bottom to sit down tight...with a rubber gasket. It would have two ears, one on each end to run a bolt through...a bolt with a bent section on the ends to utilise the holes the bale uses.. Then obviously it would have a large hole for the filler (TBD) and a smaller hole for the breather (figure AN fitting..TBD) The intention is to put a MUCH taller filler neck so its easier to fill. AN fitting on the breather is so it stops leaking or falling off. Rich |
Lo-Fi Version | Time is now: 22nd January 2025 - 06:58 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |