 Setting cam geometry, Peak cam lift or peak valve lift? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| VaccaRabite |
 Jul 8 2009, 11:15 AM
Post
#1
|
|
En Garde!  Group: Admin Posts: 13,636 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region 
 |
Jake's site is down it seems, so I am going to ask this here.
I am about to set my pushrod geometry, but I am having a brain fart. Do I use the peak cam lift or the peak valve lift. I think that it has to be within 5% of peak valve lift, but I am just not sure, and I don't want to mess it up. Also, does anyone have a copy of Jakes article for setting geometry? I pretty much remember the procedure, but I'd like to re-read it before I continue to make sure I have it right. Zach |
   |
 
|
  |
Replies
| DNHunt |
Jul 8 2009, 12:10 PM
Post
#2
|
|
914 Wizard? No way. I got too much to learn. Group: Members Posts: 4,099 Joined: 21-April 03 From: Gig Harbor, WA Member No.: 598 |
Here's a pic
Attached image(s) 
|
|
|
|
Posts in this topic
Vacca Rabite Setting cam geometry Jul 8 2009, 11:15 AM
DNHunt I measured it at the valve. It was easier to set u... Jul 8 2009, 11:28 AM Vacca Rabite That is my thinking as well.
Could someone confir... Jul 8 2009, 11:40 AM 904svo Fast answerer,
Set valve lash to zero and zero out... Jul 8 2009, 11:59 AM DNHunt Zach
That's not anything like I did.
I ran t... Jul 8 2009, 12:07 PM
Vacca Rabite
Zach
That's not anything like I did.
Yeah... Jul 8 2009, 03:29 PM McMark Half lift alignment will give your motor a longer ... Jul 8 2009, 12:19 PM charliew That is a good picture. I think the adjuster in th... Jul 8 2009, 04:57 PM Borderline Your rocker arms need to be ground down about 1/16... Jul 8 2009, 05:28 PM bam914 Here is Jake's article on rocker geometry.
ht... Jul 8 2009, 06:09 PM Vacca Rabite
Here is Jake's article on rocker geometry.
h... Jul 8 2009, 06:50 PM Jake Raby My site isn't down and hasn't been to my k... Jul 8 2009, 08:13 PM Vacca Rabite
My site isn't down and hasn't been to my ... Jul 9 2009, 12:05 AM |
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th January 2025 - 05:14 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.