 Need help from the /6 guys, "Z1" alignment |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ahdoman |
  Oct 31 2009, 05:27 PM
Post
#1
|
|
It's phonetic...Ah-D-O-Man (Audioman)  Group: Members Posts: 667 Joined: 7-November 05 From: Santa Clarita, Ca. Member No.: 5,084 Region Association: Southern California  |
I'm in the process of putting the 2.4 from "the turd" back together. Today I installed the crank pulley. Should both Z1 markings (/6 flywheel & Pulley) line up with the case centerline? When the flywheel Z1 is aligned at the case center the pulley Z1 is not. I don't see how either could be misaligned since the pulley has the pin on the back and the flywheel has the offset 6 bolt pattern. Any ideas?
Flywheel aligned on center...  Pulley not (Z1 marks are the red arrows. Sorry about the blur.)...  |
   |
 
|
  |
Replies
| ahdoman |
Oct 31 2009, 07:47 PM
Post
#2
|
|
It's phonetic...Ah-D-O-Man (Audioman) Group: Members Posts: 667 Joined: 7-November 05 From: Santa Clarita, Ca. Member No.: 5,084 Region Association: Southern California |
"The Turd" is already polished. This is the backup engine.
|
|
|
|
Posts in this topic
ahdoman Need help from the /6 guys Oct 31 2009, 05:27 PM
sixnotfour go by the pulley, remark the flywheel.
2.0-2.2 cr... Oct 31 2009, 07:14 PM
Mark Henry
"The Turd" is already polished. This is... Oct 31 2009, 08:26 PM ahdoman Mark,
That's basically what this engine is. I... Oct 31 2009, 08:58 PM Cap'n Krusty As was mentioned earlier, the crankshafts are dril... Nov 1 2009, 11:02 AM brp986s There is likely a few degrees of play in the pulle... Nov 1 2009, 02:50 PM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 09:29 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.