![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
rick 918-S |
![]()
Post
#1
|
Hey nice rack! -Celette ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 20,512 Joined: 30-December 02 From: Now in Superior WI Member No.: 43 Region Association: Northstar Region ![]() ![]() ![]() |
I finally had some time to remove the intake from the 411 parts engine I have. Is this the intake and throttle body we need? If so where do I send it?
Attached image(s) ![]() ![]() ![]() |
![]() ![]() |
ejm |
![]()
Post
#2
|
I can see the light at the end of the tunnel ![]() ![]() ![]() ![]() Group: Members Posts: 2,695 Joined: 3-February 03 From: Massachusetts Member No.: 224 Region Association: None ![]() |
Talked with Dwanye Friday night. He plans to get started on the engine this week. He says to ship the TB and gasket to Mary and he will install them when he brings the engine over.
He mentioned that when the engine was removed that several things had been cut. He remembered the throttle cable (new one on list) and ground strap had been cut and thought there was something else. Hopefully not a wiring harness. He went on a bit about when the engine is finished he plans to install the engine/trans and fire it up. Doing the install is one thing but the car would need to be fairly along in the assembly process (electrical/fuel) to get the engine running. He could do the install and come back build weekend to fire it up. |
Kansas 914 |
![]()
Post
#3
|
Advanced Member ![]() ![]() ![]() ![]() Group: Members Posts: 2,999 Joined: 1-March 03 From: Durango, Colorado Member No.: 373 Region Association: Rocky Mountains ![]() ![]() |
Talked with Dwanye Friday night. He plans to get started on the engine this week. He says to ship the TB and gasket to Mary and he will install them when he brings the engine over. He mentioned that when the engine was removed that several things had been cut. He remembered the throttle cable (new one on list) and ground strap had been cut and thought there was something else. Hopefully not a wiring harness. He went on a bit about when the engine is finished he plans to install the engine/trans and fire it up. Doing the install is one thing but the car would need to be fairly along in the assembly process (electrical/fuel) to get the engine running. He could do the install and come back build weekend to fire it up. Thanks Ed, You are right - the car will not be wired until the build weekend. The wiring harness is in now place but Mary purchased an Engman fuse panel that will be installed. Mary said that Dwayne was to assess the clutch pressure plate and disk to make sure they were good before he mated the engine/transaxle. |
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 26th June 2024 - 12:45 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |