 Pulling the Grommet for the Fuel Lines, Is There a Trick |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| kconway |
 Dec 7 2009, 08:52 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,347 Joined: 6-December 04 From: Monrovia, CA Member No.: 3,231 Region Association: Southern California  |
I'm trying to pull the rubber "grommet" under the tank that holds the two hardlines where they go through the firewall. It doesn't want to budge but I haven't really unloaded on it yet for fear of either ripping it or not getting it back in. Is there a trick and is it difficult to get it back in?
Kev |
   |
 
|
  |
Replies
| kconway |
Dec 7 2009, 11:25 AM
Post
#2
|
|
Senior Member Group: Members Posts: 1,347 Joined: 6-December 04 From: Monrovia, CA Member No.: 3,231 Region Association: Southern California |
Big rubber block.
|
|
|
|
Posts in this topic
kconway Pulling the Grommet for the Fuel Lines Dec 7 2009, 08:52 AM
jim_hoyland :popcorn: I'm getting ready to do this too..... Dec 7 2009, 09:14 AM Gint They're easier to remove after the lines are p... Dec 7 2009, 09:17 AM Vacca Rabite Pull the lines out of the grommet first. That wil... Dec 7 2009, 11:12 AM ME733 :popcorn: I will be doing this project /job soo... Dec 7 2009, 05:47 PM
SirAndy
:popcorn: I will be doing this project /job so... Dec 7 2009, 05:49 PM andys If I remember correctly, it was easier to push it ... Dec 7 2009, 06:08 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 07:36 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.