 looking to sell dellorto carbs but need info first |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ldscamaross |
 Jan 10 2010, 12:34 PM
Post
#1
|
|
Newbie  Group: Members Posts: 25 Joined: 31-January 08 From: south jordan utah Member No.: 8,646  |
hey ive got a set of dellorto carbs im looking to sell and i am trying to find out what they are exactly and how much they would be worth.
there were a few numbers on the castings. these are DRLA ( i figure that is the modle) 3012R i imagine the r stands for right side. i measured the barrel throat of the carb and it was 1.758 ish or about 44.65 mm ive got both carbs, the air filters with the crome tops, the linkage bar, and the intake runners that go between the head and the carbs. i looked on a site and the filters were around 22 a piece, the runners were around 100, and the linkage bar around sixty. ive seen them priced anywhere from 400 to 700 without the other pieces. im not sure of the conditoin of the carbs. they may need to be rebuilt. any help on prices would be great and also if your intrested in buying them let me know too. thanks andy |
   |
 
|
  |
Replies
| gopack |
Jan 16 2010, 06:22 PM
Post
#2
|
|
CHEESEHEAD in CA, MARK Group: Members Posts: 744 Joined: 7-August 04 From: Folsom, CA Member No.: 2,472 Region Association: Northern California |
not sure, but i think mine say DRLA36 on the castings, but the venturies measure well over 40 mm, so you can't go by that measurement alone. Please correct me if I am wrong ( I am sure otheres know much more than i do)!
|
|
|
|
Posts in this topic
ldscamaross looking to sell dellorto carbs but need info first Jan 10 2010, 12:34 PM
ConeDodger I am not sure where South Jordan is but AirCooled ... Jan 10 2010, 01:03 PM Mark Henry The big issue on used carbs is are they any good, ... Jan 10 2010, 01:51 PM ldscamaross bump to top Jan 13 2010, 01:51 AM ldscamaross does anybody know what size these would be based o... Jan 16 2010, 05:59 PM ME733 :popcorn: ...Well a few photographs could help...a... Jan 17 2010, 07:26 PM Jake Raby The reason the top of the carb is 40mm is because ... Jan 17 2010, 08:54 PM
ME733 :popcorn: The reason I Was able to give you some d... Jan 18 2010, 12:08 PM |
6 User(s) are reading this topic (6 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th December 2024 - 01:57 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.